I have a complex horizonal alignment with active profile. i need to copy part of this geomety along with adequate part of vertical alignment.
I try few ways with no success:
1) Single offset partial with toogled on "3D" lock on feature definition toolbar
-geometry is copied without its vertical
2) Single offset partial and then profile element with original alignment as reference
-what I get is unruled profile, I drop that profile and get linestring with hunderds of handles. I wish it were vertical elements
3)Single offset partial and then profile slope from element
-the result is the same ai in worflow no. 2.
any idea, what would be the successful workflow.
Adam
BTW
I work with a priority build .498 of InRoads now. Software stops responding several times per hour.I am not sure whether it is a matter of software or my PC configuration. Just an example, choosing complex element Properties from context menu, hangs InRoads and a error message is displayed. Then it starts respondin again until I try to set feature definition with approperiate tool or change it via Project Explorer and element info.