Cross Sections XSCELL not showing due to Station Equation

All,

I'm using Power GEOPAK v8.11.9.832

I have an alignment that begins at 1099+00 R1 and ends at 1244+50 R4, one of my station equations has a back station at 1184+68 R2 and a ahead station at 1176+38 R3. When I generate cross sections, the XSCELL does not show for stations 1176+50 R3 - 1184+50 R3. The XSCELL will show up for stations before and after this range. So when I use the Cross Sections Navigator, it will skip these stations.

Here is a picture of the XSCELL:

Here is a picture of a station without the XSCELL:

Any suggestions would be much appreciated.

Thanks,
Jason