(Posted on behalf of Be Communities Member)
I have a dgn with a control line defined by horizontal and vertical. The alignment only shows the rules/design constraints at a particular view scale. I need to zoom in and out numerous times to view the rules. Also, I have a short piece of straight between two arcs. Because of the length of straight being so small, it does not show the bearing and distance of the element and therefore I can not make changes to it. I have to reduce the radius of either arc before and after, which then allows me to make changes to the rules of the straight element.
Can I put in a suggestion of improvement - the "blue" rule text is incredibly difficult to see. There needs to be a way to change this.