hello,
Regarding ditches: until ss3 I could design (InRoads) a VA(vertical alignment) for my main roadway and separate VAs for left and right ditches along this main roadway. These VAs for ditches usually had a Style assigned (one for Left and another for Right ditch). Then in Create Template, when developing End Conditions (EC) branches I set Style Elevation as ditches' targets. I'd rather not use point control for ditch elevation but simply the StyleElevation as an EC target. Then in my corridor EC would search for specified style elevation.
I know that with SS3 release I will need to change my workflows a bit. But still, can you advise what is the suggested workflow for designing typical ditches (with proposed VA).
Kindly,
Adam
BTW. targeting Style Elevation was quite efficient - there was no necessity to take care of VA names and we could develop universal templates with End conditions that were suitable for many different designing tasks across organization. I hope I am clear enough.