I have produced a series of corridors in separate DGN models using 2d seed files. Each of these DGN files contain the survey ground terrain model referenced into each of them as the active terrain model.
When I create a new DGN file (2d Seed) I want to reference in a particular corridor model. I set the nesting level to 1 so that I only get the Default 3d Model component of the reference DGN but it seems to keep bringing the terrain model in. This starts to become a problem when each DGN model referenced in contains the existing ground terrain model.
How do I get around this? If I apply no nesting to the reference DGN corridor then I don't receive the 3d component of the corridor?
Thanks, Dan