Hi All,
I imagine there's a simple answer to this but we can't quite figure it out.
When drawing a set of cross sections, the sections are drawn out of sequence.
For example, say for sections drawn from Ch0 to Ch1000, you would expect Ch0 section to be at the bottom left and Ch1000 section to be the last section at the top right.
However, I may have a block of sections starting at say Ch220 at the bottom left, drawing in sequence until it gets to Ch1000, then continuing with Ch0 and finishing at Ch210 at the top right.
Has anyone else experienced this, is it due to the sequence of how models are sections etc?
Would be very interested to solve this one, because it takes time correcting the sequence manually.
Cheers,
Ade.