Adam
The PowerSurvey SS2 DTM tools are the same as InRoads SS2, but not all are available.
After doing the isopach command, the resulting DTM can be displayed with "Display contours" . If the first and second DTM are really cutting themselves, then the 0-Zero contour can be displayed only when setting a huge intervall value, like 1000.
There is a open CR for doing:
- Isopach command
- displaying 0 zero Contour and
- Cut and Fill Shaped areas
- calculation cut and fill volume
- dividing cut and fill surface in two own DTM-files, with correct exterior boundaries
within one seamless work flow