Hello,
I am new to Geopak V8i SS2.
I am learning the D&CM functionality. I understand the Set mode in the D&CM will change the symbology of selected item to that of category selected in left pane of manager. However, I select the category, select Set, then Identify element (element highlights), then select data point off element to accept; but nothing happens. Even though I am not prompted to Accept. The bottom left message tray continues to read "Identify Element to be set". I have also tried this workflow on different, more obvious linetypes, to ensure I am not just missing the visual change and I confirm that no change is taking place. The dialog selections I am using are shown in attached image. What am I missing that is preventing the Set command to work?