I received a tip last week from Derricke Gray on a good idea for additional Project Settings - Design Stages. We added 4 new design stages to the Bentley-Civil Example Workspace that will be available in our next release. We added one for Top Mesh Only, Bottom Mesh Only, Linear Features Only, and Components Only. These are all Final design stages and make it a lot easier to get the correct information for machine control and terrain model creations. If you want an updated copy you can get it here. Note the paths are setup for Power GEOPAK, but it works for PG, PI, Inroads and GEOPAK Suite and MX. Just update the files that were delivered with your install after unzipping.
ftp.bentley.com/.../SS3Standards_05_21_2013.zip
Note, as we continue to update our example workspace I will continue to update this thread. Note, the posted link will be good for a few weeks.
Thanks,
Chuck