Hello,
I need to find exact Stations along an alignment where Barriers transition from one type/size to another. I am using Select Series 2 InRoads version 8.11.07.566. I can't find any reports that will do this; length is the closest I can find. My surface includes a complex barrier template that will change from one size of a barrier component to another, depending on Display Rules. I would like to pick a Feature point/s in the template and have it report the stations where it is used, and the length as well if possible. I need these transition stations in order to annotate the Wall Envelope/Profile, and it would be helpful for quantities as well.
My current workflow, which only works for short runs of a few hundred feet, is to drop the template every 0.1' or 0.01' (best case scenario). Then I can simply cycle through station by station until I find where each Wall Type transitions to the next size. The problem is that this only works for short runs and it can take a long time to process.
This would be impossible on a 1 mile sound wall project for example. I also tried the Tools>Design Input Report command in the Roadway Designer, but that didn't give enough information to determine where the transitions occur. Thanks for any advice,
Jon Blanchard