Hi Chris,
I am using MicroStation V8i(Select series 3) - Version 08.11.09.357. Bentley InRaods V8i (Select series 2) V08.11.07.566.
I think you may have been correct in the Element Snap. I checked and it was off, as was the Point Snap. I turned on the Point Snap.
I am getting an Elevation and a Slope for that point. The question now is I need the Slope relevent to the next point. I don't know
where the slope is applied to, it gives me a slope based on just one snap. How do I know?
19.32 to19.36
What I am trying to achieve here is a slope of a segment of a pavement for Handicap Accessibility and whether or not the
Ramps were built correctly. We believe they were not. So my Boss is asking me to put a slope in for each segment of
pavement. For example the Elevation at the lowest part of the Truncated Dome is 19.32 the next part is 19.36 followed by 19.43.
I need a slope for these two segments. 19.32 to 19.36 and 19.36 to 19.43. Can you help?
Peggy Bacon
302-760-2352