RE: create station equation
Certain features are set up in SS3 to "persist" your geometry to a "Native" format (GPK,ALG,MX). I believe this is done to allow for access to tools within the "Native" toolset. You do not (or should...
View ArticleRE: TDS codes - PC & PT Does not work as feature code anymore in SS3
MauritzjIt is Openroads in SS3
View ArticleRE: TDS codes - PC & PT Does not work as feature code anymore in SS3
Hi Caddcop,I was looking at a few different job files this morning and found the same HR error you had talked about multiple times with each file, when I tried it in Openroads, I got the error, but if...
View ArticleRE: Inserting HIP with spiral-arc-spiral
Hi Dan,Once you've inserted the vertex, you can use the Arc Between Elements tool to add the arc. Because you're trying to add the arc to a complex, note that you need to use the Alt key when you are...
View ArticleInserting HIP with spiral-arc-spiral
I have a complex element where I have inserted a new HIP using the "Insert Vertex" under the main toolbar. I can't seem to find how to insert a horizontal curve with spiral transitions for this IP...
View ArticleCivil Cell for Continuation of Geometry
I am wanting to create a civil cell for some standard geometry shown in the picture attached. I have an existing control line (green) and want to create another control line that is uses the existing...
View ArticleRE: Civil Cell for Continuation of Geometry
Hello again Dan,Have you tried using the Line From Element tool to construct the new piece of geometry? It should do what you want - i.e. maintain the bearing of the existing control line.Regards,Jon
View ArticleRE: How to show K value in profile
Ian can send the file path again.RegardsSreenivasulu
View ArticleClik here to view.
Vertical Geometry
Hi.They have asked me for a rail project to model an alignmenI want to do this in SS3 but now I run into the following problem. I want a radius between two elements with a fixed radius and a fixed...
View ArticleRE: How to show K value in profile
Below is the link to the example input file.MX Longsection Profile With K-Value
View ArticleHow to show K value in profile
I AM TRYING TO SHOW K value , it is showing R value anybody can helpme.Sreenivas
View ArticleClik here to view.
Manipulators are gone!!
Hi.I have problems with the Manipulators, on one side it seems ok, when I zoom to the other side of my geometry they are gone.Please help!!
View ArticleRE: TDS codes - PC & PT Does not work as feature code anymore in SS3
Only TDS RAW, or all data collector file formats?
View ArticleCombine Multiple Vertical Alignments Into One Vertical Alignment
I have multiple proposed vertical alignments attached to one horizontal chain that I would like to combine into one proposed vertical alignment. Can this be done in Power GEOPAK 08.11.07.615?
View ArticleRE: [SS3g] Manipulators missing on 1 of 2 profiles
Hi Mike,The message you are getting when you import the GPK explains (kind of) why the profile is not being ruled. The help file for the Import Geometry command notes that there are certain criteria...
View Article[SS3g] Manipulators missing on 1 of 2 profiles
In the attached file the manipulators for the left profile will not display when the profile is selected. The manipulators will appear when the right profile is selected. Vertical Alignment reports can...
View ArticleClik here to view.
RE: Manipulators are gone!!
As Mike said, there is no civil geometry included in this design file, as evidenced in the Project Explorer. I would not expect any of the manipulators or any other commands to work properly in this...
View ArticleRE: Vertical Geometry
Hi CP,It seems as if you may want to place your curve first, and then use the Tangent Profile Line From Element command to run your line tangent.Thanks
View Article