I have a question I hope I can explain in this post.
I have a simple template that is 3.5" thick with an 11' lane NB and an 11' lane SB crowned in the middle at 2% slopes. I have a CL alignment down the center of the road and I also made an horizontal and vertical alignment of the ex curb line roughly 35' left of the CL. What I WANT to do is have the curb line H/V be the controlling alignment and rubber band at 2% right up to the road CL and then 2% down for 11' right of the road CL. I have point controls set for H/V at left top of template that are to seek the ex curb H/V alignments that I created and another point control for my crown point to seek the road CL horizontally only. In corridor manager, I have set the alignment to the ex curb H/V (not road CL). When I run my model the crown point seeks the road CL and my control point is seeking the ex curb and gutter line but the rubber banding left side is not at 2% it is at a steady .62%. What am I missing? Attached is a pic of what I am trying to accomplish.
