Gentlemen, Thank you for your direction.
As I stated earlier, I was not associated with the creation of this particular file. There are over a thousand elements in this file.
I have 'viewed' the alignment and I see Sta, Offset, Elev, Grade & Radius (after I did a "View Previous" because I went out to space again when I picked a x-sect)........Is THIS what is supposed to be the affect I get? If so, I was hoping that if I picked a x-sect I would go to the plan view and see THAT area where the x-sect was cut like Geopak does or did, it's been a couple of years since I've used Geopak.