Hello,
I am new to Geopk V8i SS2.
I have been using a workflow to eliminate regions in my alignment chain by going to Graphical Coordinate Geometry->Navigator->double clicking the chain in question, then the "Store Chain from Elements" dialog pops-up. I change "Station As Is" to "Begin Station" from the pull-down, then select my chain in right hand window, select "add" to left hand window, then select "Store Chain" and get (see attached image) in the Coordinate Geometry Display. Is this workflow correct? I am wondering if I should be erasing the left hand window before I select add to add chain to left hand window. Also, I raise the question because every time I do this, then try to do some other operation on the alignment chain that was redefined, such as label stationing, visualize thru navigator or add patterns, the program locks-up. I am apparently not clear on this workflow. Can someone let me know what I am missing in the above steps or perhaps there is a better way to remove regions from an alignment?